Hasselblad 10026 service manual Rear plate

Page 17

4:5

Camera body 503CW

Reassembly

Rear plate (30300)

Fitting the rear plate

Fig. 23 and 24.
Lubricate the shutter driving arm’s shaft hub and the
mirror’s moving peg with grease. Connect the arm and
the connecting rods and fix the rear plate into the
chassis. Ensure that the mirror actuating lever grips the
pin on the mirror frame and that the mirror is
positioned correctly on the upper side of the mirror
support.
Connect the driving arm (22781) to the mirror frame
and secure with a clip (817115). Do not forget the
washer (810649) between the frame and the arm.
Check that the mirror and shutter driving arms move	Fig. 23
freely.

Secure the rear plate to the camera using six screws (820015) and two screws (821017).

Check that the mirror and the auxiliary shutters are centred and move freely. Adjust if necessary the brackets (Qty. 4) in the side hinges of the auxiliary shutter and mirror frame.

If the magazine hook (22423) has been removed, put it back with two screws (823640) and seal the screws with loctite.

Seal between the rear plate and both side walls using black silicone or similar. (Lower and upper end).

820015

820017

Fig. 24

Revision 0

October 1996

Image 17

Contents Göteborg Sweden Victor Hasselblad ABContents list Camera body 503CW Signal arm shortened 501C and 503CXi Updated pages 503CXiFitted with wrong spacers 503C/M and 503CX Flash metering circuit redesigned 503CX04/01 New CD-ROM Version Camera type General descriptionRelease sequence Tools Used for Tool No DescriptionTool No Description Used for Camera shell Rear plate 30300 including auxiliary shutter Circuit board 22575 *22882Front bayonet plate Mechanism plate Focusing screen frameRight hand wall Gear housing Reassembly 816802 Fitting the mechanism plate to the right hand wall 821631 13108 814827 13355 13280 13362 Rear plate Intermediate gear Perform the necessary adjustment as described in sectionFront plate Adjustment Focal length Adjustment of the front key’s angular positionAngle 15-16 o with the bayonet plate tool 904644 pushed Adjustment of the release mechanism 15 mm Adjustment of the release sequence Fitting the damping ring Fitting the Circuit board 22575 *22882 Adjustment Fitting the camera body into the shellFinal checks 510 Camera body 503CW 511 Camera body 503CW 512 Camera body 503CW 513 Camera body 503CW Front gear Front plate reassemblyFront bayonet plate Exchanging the auxiliary shutter Exchanging the mirrorShim washers Revision May Pos Pcs Spare Description Remark May Camera body 503CW Camera body 503CW Camera body 503CW September Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW Camera body 503CW October May Camera body 503CW Camera body 503CW 151 Spare parts not listed are the same as for 503CW 152 152 153 153 154 154 155 Coupling Crank support 161 Pos Pcs No Spare Part No Description Remark 162 Pos Pcs Spare Description Remark 163 163 171 171 172 172 173 173 174 174 175 175 181 181 182 182 183 183 184 184 185 January 191 October 192 192 193 193