Sterling SSV 05/2R operating instructions Filling level too low, Filling level too high

Page 24

SSV 05/2R

4.3. Basic setting of the filling level in the conveyor hopper

The filling level in the conveyor hopper is mainly determined by the level probe.

Filling level too low

By means of a screwdriver, turn the adjust- ment screw of the level probe (A)

¼ rotation counterclockwise.

Observe the filling level during the next con- veying procedure.

Repeat the process until the desired filling level in the conveyor hopper is reached.

Filling level too high

A

By means of a screwdriver, turn the adjustment screw (A) of the level probe ¼ ro- tation clockwise.

Observe the filling level during the next conveying procedure.

Repeat the process until the desired filling level in the conveyor hopper is reached.

SM4-610

Set-up 23

Image 24
Contents Operating Instructions Single Conveyor Unit SSV 05/2R Sterling Material ProcessingTechnical service SSV 05/2R Sterling Material ProcessingEdition 08/99 SSV 05/2R Parts and Service Department Table of contents SSV 05/2R Technical data Safety instructions Safety instructionsSSV 05/2R SSV 05/2R Explanations and information SSV 05/2R For your safety SSV 05/2R SSV 05/2R SSV 05/2R For the safety of the units Installation instructions SSV 05/2R General information SSV 05/2R Installing the conveyor hopper SSV 05/2R Installing the control and maintenance unit SSV 05/2R Connecting the compressed-air supply SSV 05/2R Electrical connection Functional description Control and maintenance unit SSV 05/2R Method of functioningSet-up Setting the mixing ratio of the components SSV 05/2R PreparationsFilling level too low Filling level too highSet-up Maintenance SSV 05/2R Maintenance intervals SSV 05/2R Cleaning/replacing the filter cartridge DisassemblySSV 05/2R Assembly Adjusting the level probeSSV 05/2R Trouble-shooting Problem Remedy Test stepsTechnical data SSV 05/2R Dimension sheet SSV 05/2R Spare parts list SSV 05/2R Pos ID-No Designation