JVC TK-C1430 manual Motion Detect Screen, Area Edit, Alarm Time

MENU SETTING

MOTION DETECT Screen

Settings are executed about the motion detecting function that emits alarm signals when there exists any motion in the image. Alarm signals are output from the auxiliary terminals on the back.

Item		Functions and set values	Initial value
MODE	This sets ON/OFF of motion detecting function.		OFF
	OFF:	Motion detecting function does not work.
	ON:	Motion detecting function works.
LEVEL	This sets the level that detects motion.		NORMAL
	If the item MODE is set to OFF, “- - -” will appear, and
	settings cannot be changed.
	To function with large signal level change…decrease the
	value
	To function with small signal level change…increase the
	value
	[Set values: –5 to NORMAL to 5]
AREA EDIT	This sets the range in which the motion detecting function		–
	works.
	( Page 39)
ALARM TIME	This sets the output time of the alarm signal output of		10s
	AUX terminal as well as “ALARM” display on the screen
	when motion is detected.
	If the item MODE is set to OFF, “- - -” will appear, and
	settings cannot be changed.
	[Set values: OFF, 5s, 6s, 7s, 8s, 9s, 10s, 15s, 20s, 30s,
	1min]
	MEMO
	Even when the ALARM TIME item is set to OFF, an alarm
	signal is output from the AUX terminal for about 500ms,
	and “ALARM” is not displayed on the screen.
DEMONSTRATION	This is used when checking and confirming the set motion		–
	detecting function. The detection area is shown in gray.
	( Page 39)

E-34