Panasonic AW-E560 manual GEN-LOCK Adjustment, Horizontal Phase Control

■GEN-LOCK ADJUSTMENT

Phase adjustments must be performed with the camera or the RCU (RCB) when external synchronizing signals are supplied to the system in cases where multiple cameras are used or peripheral devices are connected.

ENC	OFF
	PAGE	ITEM	UP	DOWN
VF	ON		SC PHASE
USER SET		COARSE		FINE
H.PHASE		0	270
		90	180
Horizontal phase				Subcarrier phase
control				fine control

Subcarrier phase coarse control

■HORIZONTAL PHASE CONTROL

Observe the waveform of the external synchronizing input signal (black burst signal) and video output signal on a two-channel oscilloscope. Then match the horizontal phase of both signals by adjusting them with the cameras or RCU's horizontal phase control.

External gen-lock input signal (black burst output of special effect generator)

Video signal

[ADJUSTMENT by CAMERA]

1.Press the BAR (DOWN) switch for over 1 second to display the color bar.

2.Select page No.4 of INITIAL SET menu.

3.Select “H PHASE” with the item switch.

4.Adjust the horizontal phase with the Up switch and Down switch.

NO.4 ** INITIAL **

H PHASE	+	....	I....	-
SC COARSE		0°
SC FINE	+	....	I....	-

RET END

[ADJUSTMENT WITH RCU (RCB)]

Use the horizontal phase control located in the pocket of RCU (RCB).

-29-