(4)To return to the SETUP menu state, move the cursor to RET and press the page switch.
(5)To change gain up, move the cursor to GAIN in the SETUP menu, and use the Up or Down switch. (This applies in cases where the camera is used alone.)
■User Set Memory Reset
The
(1)Switch camera power off, and switch it back on.
(2)Complete the operation mode/USER file setting and press the page switch. When the new settings for reset are displayed, press the page switch again for about 2 seconds while "CURR: MODE 1/USER A" is displaying on the screen then the screen shown at right on the top appears.
(In case of USER B, RESET USER B? appears on the screen.)
(3)If YES is selected by pressing the Up switch within about 10 seconds after the screen shown in Step (2) appears, the user set memory is reset, a message appears as shown at right, and the operation returns to normal state.
(In case of USER B, NOW RESET USER B MEMORY appears on the screen.)
(6)To return to the normal state, do the following steps.
If the camera is used alone, move the cursor to END, and press the page switch.
If the camera is used with an RCU (RCB), set the user set switch to OFF.
The camera will then operate according to the set- tings.
RESET USER A? (MODE1)