Panasonic AK-HC1500G GAIN, Auto Iris, Iris Level 0 to, Iris PEAK/AVE 0 to, Iris Mode LENS, CAM

Page 31

Setting of menu items

ENGLISH

MAINTENANCE menu

[8]GAIN, AUTO IRIS

�� GAIN,AUTO IRIS ��

LOW GAIN	:0dB
MID GAIN	:9dB
HIGH GAIN	:18dB
A.IRIS LEVEL	:050
A.IRIS PEAK/AVE	:050
A.IRIS WINDOW	:NORM1
IRIS MODE	:LENS
IRIS GAIN	:05

LOW GAIN [–6 dB to 30 dB]

MID GAIN [–6 dB to 30 dB]

HIGH GAIN [–6 dB to 30 dB]

For setting the amount by which the gain is to be increased when LOW, MID or HIGH has been selected by GAIN SELECT.

A.IRIS LEVEL [0 to 100]

For adjusting the target level (brightness) of the auto iris.

A.IRIS PEAK/AVE [0 to 100]

For setting the ratio between the auto iris light-metering peak value and average value.

A.IRIS WINDOW [NORM1, NORM2, CENTR] For setting the auto iris light-metering area.

NORM1: The light is metered on the entire screen (except around the edges).

NORM2: The light is metered on the entire screen (except at the top).

CENTR: The light is metered only in the area at the screen center.

IRIS MODE [LENS, CAM]

For switching between the iris gain control on the lens (LENS) and the menu (CAM) to adjust the focusing speed of the auto iris.

Normally, LENS is selected, and the speed is adjusted using the iris gain control on the lens.

IRIS GAIN [01 to 10]

For adjusting the iris gain when CAM has been selected as the IRIS MODE setting.

- 30 (E) -

Image 31

Contents Multi Purpose Camera AK-HC1500GFCC Note English VersionEnglish Important Safety Instructions For business users in the European Union Accessories ContentsIntroduction Characteristics Cooling fan Precautions for useBottom view Rear view Front viewMajor operating controls and their functions  HD SDI output connector HD SDI OUT  Tally output connector Tally OUT Iris control cable to Iris connector How to set the lensConfiguration example 1 Connection of camera controller How to set up the systemConfiguration example 2 High-Speed P/T system Start shooting Operation procedureAdjust the white balance Adjust the black balanceAuto iris power zoom lens How to adjustFlange back adjustment for zoom lens Lens iris gain volume adjustmentColor temperature and white balance adjustment reference White balance adjustmentGen-lock adjustment Black balance adjustmentTOP menu Setting of menu itemsHow to display the menus  Using AK-HRP150G camera controllerCorrectdig OFF, on  Maintenance menuBlack Shading Detection READY, ActiveGamma PEDESTAL, GammaCine Gamma Select Video REC, Film REC Gamma OFF, onBlack Gamma OFF, on DRS OFF, onFlare 000 to FlareFlare OFF, on Knee Point -25.00% to +25.00% KNEE, White ClipKnee Point 80.00% to 107.00% Video Menu 30% to 90% Film MENU/VIDEO RECKnee Level 100% to 109% Knee Point 80.00% to 107.00%White Clip LVL 90% to 109% High Color OFF, on B GainKnee OFF, MANUAL, Auto White Clip OFF, onDetail OFF, on DetailKnee Aperture OFF, on Detail Source Slim Detail OFF, onSkin Tone DTL OFF, on Skin Tone DetailSkin GET OFF, on Iris PEAK/AVE 0 to Iris Mode LENS, CAMGAIN, Auto Iris Iris Level 0 toSuper Gain Mode S.GAIN1, S.GAIN2, S.GAIN335 to 0.75 DRS OFF -10 to +10 DRS on Peak Frequency 0 toPED Offset -200 to +200 Frame Rate Range 60-6 Frame ModeFrame Rate 60 to Matrix Table A, B MatrixColor Correction LOW, MID, HIGH, S.GAIN1 to  Setting menuMode Gain SelectBAR SEL Matrix Table OFF, A, BColor Correction OFF, on Digital Extender OFF, onAWB OK FormatStatus OFF, on AWB ActiveFAN OFF, AUTO, on ABB OKOUT Range RGB Menu on BAR OFF, onShutter Speed ShutterSynchro Scan Auto Detection GEN-LOCKPIX Defect GEN-LOCK Input BNC, DsubProtocol 1 to Protocol Camera ID menu Execute Mode LOAD/STORE File Operation menu LOAD/STORE fromPreset Reset Time Code menu Menu list 47 E 48 E Unit inch mm AppearanceInput/output signal SpecificationsControl cable for information camera Appendix