20 en Installing a Surface Mount |
|
|
|
CAUTION!
To prevent humidity problems, the camera must be installed in dry conditions, and the cable leads should be sealed after they are connected.
1.Determine a secure location that can support the weight of the dome.
2.Use the template (refer to Figure 6.1, item 1) to mark the locations of the four screw holes and the cable conduit.
3.
4.Cut out the entire cable conduit hole.
5.Insert the four plastic anchors (item 2) inside the pre- drilled holes.
6.Route the cables from the camera through the conduit in the ceiling.
7.Remove the dome cover (item 6) from the camera base (item 3).
NOTICE!
To prevent scratches on the dome cover, Do Not Remove the plastic film protecting the dome cover until after hardware installation is complete.
8.Remove the white foam ring from the camera base, and remove the white foam sheet from the inside of the dome cover. (These are for protection during transport.)
9.Align the four screw holes on the camera base (item 3) with the four plastic anchors.
CAUTION!
When (re)mounting the camera base, make sure that each mounting screw has a rubber
10.Attach the camera base to the ceiling using the four #8 x 32 screws (with
F.01U.252.635 2.0 2011.09 | User Manual | Bosch Security Systems, Inc. |