Bosch Appliances VEZ-400 Setting the address ID of the camera, Setting the protocol of the camera

28 en Connection VEZ-400 Mini PTZ Dome

6.5.1Setting the address (ID) of the camera

To prevent faulty operations and malfunctions, each camera must have an unique address (ID). The default setting is 0[ID001].

X0 X1

SW301 SW302

Table 6.5 Dome Camera ID Setting (Rotary Switches SW301, SW302)

6.5.2Setting the protocol of the camera

Set the protocol setting, the baud rate, and the termination setting of dip switch SW303, using the data in the tables below. Note: The value marked * is the default setting.

No1	No2	Protocol
Off	On	Bosch OSRD*
Off	Off	Pelco-D/Pelco-P
Table 6.6		Camera Protocol Setting (No. 1 & 2, Dip Switch SW303)

No3	No4	Baud Rate (bps)
Off	Off	2400
Off	On	4800
On	Off	9600*
On	On	38400
Table 6.7		Camera Baud Rate Setting (No. 3 & 4, Dip Switch SW303)

No5 Termination

Off Off

On On*

Table 6.8 Camera’s RS-485 Termination Setting (No. 5, Dip Switch

SW303)

NOTICE!

When the RS-485 signal is looped through, make sure that (only) the last device is properly terminated. Improper RS-485 wiring or termination may result in unreliable system operation.

F.01U.252.635 2.0 2011.09 User Manual Bosch Security Systems, Inc.