|
|
ALARM SETUP
BACK
- SET/CLEAR
3.Select the appropriate alarm number.
4.Select the option "In" to select the alarm input type.
5.Select the appropriate value: N.O. (Normally Open) or N.C. (Normally Closed).
6.Select the option "Out" to select the alarm output.
7.Select the appropriate value: ON or OFF.
8.Select the option "Priority."
9.Select the appropriate priority from
10.Select the option "Action."
11.Select the appropriate action: Off, Preset, Pattern, Scan, or Tour.
12.Select the option "Number."
13.Select the number of the action (Preset, Pattern, Scan, or Tour).
14.Select the option "ATime" to set the alarm time for the action.
15.Set the desired dwell time:
–Time Out
–Momentary (On): When an alarm is triggered, the camera will maintain alarm activation continuously, until it is stopped manually (96+preset in Pelco protocol; [Off]+[65]+[Enter] in Bosch protocol).
16.Save the settings.
Note: Select the option "Clear" to delete the alarm.
NOTICE!
In order to call an action (Preset, Pattern, Tour, or Scan), you must save Preset, Pattern, Tour, or Scan first.
Bosch Security Systems, Inc. | User Manual | F.01U.252.635 2.0 2011.09 |