Installation en 17 | |
|
|
4Installation
4.1Preparations
CAUTION!
The camera is intended for indoor and outdoor use.
Select a suitable location for installation that guarantees to meet the environmental conditions. The ambient temperature must be between
Please ensure the following installation conditions:
–Do not install the unit close to heat sources. Avoid locations exposed to direct sunlight.
–Allow sufficient space for running cables.
–Ensure that the unit has adequate ventilation.
–When making connections, use only the cables supplied or use appropriate cables immune to electromagnetic interference.
–Ensure to use cables matching the installation location. For example, use cables marked “Outdoor Cable” or “Water Resistant” for outdoor installation. For the US, cables must comply with NATIONAL ELECTRICAL CODE, NFPA 70.
–Position and run all cables so that they are protected from damage, and provide adequate cable strain relief where needed.
–Avoid impacts, blows and severe vibrations that exceed the specification limits (see Section 9 Specifications, page 104), as these can irreparably damage the unit.
4.2Mounting
You can mount the camera to mounts or pan/tilts and place it to walls, below ceilings, on roof tops or poles or any other
CAUTION!
The camera must be properly and securely mounted to a supporting structure capable of sustaining the unit weight. Use care when selecting mounts or pan/tilts (not supplied) for installation; the mounting surface and unit's weight should be carefully considered.
CAUTION!
If the camera is mounted to a pan/tilt, ensure that your hands do not get caught or crushed between camera and pan/tilt.
Bosch Sicherheitssysteme GmbH | Installation and Operating Manual | DOC V4.5 2010.09 |