Bosch Appliances VOT-320 3Connections, Network, Pin EIA/TIA-568-A EIA/TIA-568-B, Data interface

VOT-320 Installation en 19

4.3Connections

Network

You can connect the VOT-320 to a 10/100 Base-T network using a standard UTP category 5 cable with RJ45 plugs.

Pin	EIA/TIA-568-A	EIA/TIA-568-B
1	white/green	white/orange
2	green	orange
3	white/orange	white/green
4	blue	blue
5	white/blue	white/blue
6	orange	green
7	white/brown	white/brown
8	brown	brown

1.First crimp the wires according to the EIA/TIA standard you are using.

2.Connect the VOT-320 to the network via the RJ45 socket on the back of the camera module.

Data interface

The bidirectional data interface is used to control units connected to the VOT-320, such as pan/tilts that are not connected directly to the P/T connections (see Section Pan/tilt connection, page 20). The connection supports the RS-232, RS-422 and RS-485 transmission standards.

The VOT-320 offers the serial interface via the upper 6-pin terminal block (see Section 8.8 Terminal blocks, page 99).

The range of controllable equipment is expanding constantly. The manufacturers of the relevant equipment provide specific information on installation and control.

CAUTION!

Please take note of the appropriate documentation when installing and operating the unit to be controlled.

The documentation contains important safety instructions and information about permitted uses.

NOTICE!

A video connection is necessary to transmit transparent data.

Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC V4.5 2010.09