Pioneer AVH-P4950DVD operation manual Using nonfading output, Boosting the subwoofer level

Section

03 Operating this unit

3Touch band then touch cor dto se- lect the phase of subwoofer output. Touch dto select normal phase and NORMAL appears in the display. Touch cto select reverse phase and REVERSE appears in the display.

4Touch band then touch cor dto ad- just the output level of the subwoofer. Each time you touch cor dincreases or de- creases the level of the subwoofer. +6 to –6 is displayed as the level is increased or de- creased.

5Touch band then touch cor dto se- lect cut-off frequency.

Each time you touch cor dselects cut-off fre- quencies in the following order: 50Hz—80Hz—125Hz

Only frequencies lower than those in the se- lected range are outputted from the subwoo- fer.

Using nonfading output

When the nonfading output setting is on, the audio signal does not pass through this unit’s low pass filter (for the subwoofer), but is out- putted through the RCA output.

1Touch NON FADING on the audio func- tion menu.

# When the subwoofer controller setting is only FULL, you can select NON FADING. (Refer to page 43.)

2Touch ato turn non fading output on.

# To turn non fading output off, touch b.

3Touch cor dto adjust the output level of the non fading.

Each time you touch cor dincreases or de- creases the level of the non fading. +6 to –6 is displayed as the level is increased or de- creased.

Boosting the subwoofer level

You can easily boost the subwoofer bass level by repeatedly pressing BOOST button. If the subwoofer is set to OFF, pressing BOOST but- ton automatically sets the subwoofer to ON.

%Press BOOST button to increase the subwoofer level.

The subwoofer level 0 to +6 is shown in the display.

# To decrease the level, press BOOST button and hold. The subwoofer level is reset to 0 and then you can start again.

Note

You can also select the subwoofer level in the audio menu. Refer to Using subwoofer output on the previous page.

Using the high pass filter

When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are outputted from the front or rear speakers.

1Touch NEXT on the audio function menu.

2Touch HPF.

3Touch ato turn high pass filter on.

# To turn high pass filter off, touch b.

4Touch cor dto select cut-off fre- quency.

Each time you touch cor dselects cross-over frequencies in the following order: 50Hz—80Hz—125Hz

36 En