Pioneer AVH-P4950DVD Switching the auxiliary setting, Setting the illumination switch

Operating this unit

%Touch D. WARN on the initial menu to turn warning tone on.

# To turn warning tone off, touch D. WARN again.

Switching the auxiliary setting

It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit.

%Touch AUX on the initial menu to turn auxiliary setting on.

# To turn auxiliary setting off, touch AUX again.

Setting the illumination switch

You can choose whether to have the illumina- tion of this unit switch on/off when the ignition key is turned to the ACC position or the power- off position.

%Touch ILM SW on the initial menu to turn the illumination switch on.

Set the illumination switch ON to have the illu- mination of this unit remain on when the igni- tion key is turned to the ACC position. Set to OFF to have the illumination off when the igni- tion key is turned to the ACC position.

# To turn the illumination switch off, touch ILM SW again.

Note

Never set the illumination switch on if the vehicle does not have the ACC position. It may cause bat- tery leakage.

Section

03

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out-	Operating
ting to SUB. W, you can connect a rear speak-
put and RCA rear output) can be used for full-
range speaker (FULL) or subwoofer (SUB. W)
connection. If you switch the rear output set-
er lead directly to a subwoofer without using	this
an auxiliary amp.
Initially, the unit is set for rear full-range speak-	unit
er connection (FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect the RCA sub-
woofer output to a subwoofer. In this case, you
can select whether to use the subwoofer con-
troller’s (low pass filter, phase) built-in SUB.W
or the auxiliary FULL.

!When the multi-channel processor (e.g., DEQ-P7650) is connected to this unit, you cannot operate this function.

1Touch NEXT on the initial menu.

2Touch REARSP.

3Touch aor bto switch the rear output setting.

Touch ato select full-range speaker and FULL appears in the display. Touch bto select sub- woofer and SUB. W appears in the display.

# When no subwoofer is connected to the rear output, select FULL.

# When a subwoofer is connected to the rear output, set for subwoofer SUB. W.

# When the rear output setting is SUB. W, you cannot change the subwoofer controller.

4Touch cor dto switch the subwoofer output or non fading output.

Touch cto select subwoofer output and SUB.W appears in the display. Touch dto se- lect non fading output and FULL appears in the display.

En 43