Pioneer AVH-P4950DVD Setting remote control code type, If you forget your code number

Operating this unit

1Touch SETUP and VISUAL and then touch PARENTAL.

2Touch 0 to 9 to input the registered code number.

3Touch ENTER.

This enters the code number, and you can now change the level.

#If you input an incorrect code number, the

icon is displayed. Touch C and input the cor- rect code number.

#If you forget your code number, refer to If you forget your code number on this page.

4Touch any of 1 to 8 to select the desired level.

The new parental lock level is set.

If you forget your code number

Refer to Changing the level on the previous page, and touch C 10 times. The registered code number is canceled, letting you register a new one.

Setting remote control code type

When the remote control operation switch is set to DVD, changing the remote control code type enables you to operate the Pioneer DVD player with the supplied remote control. There are three remote codes, code type A, code type B and code type AVH. When operating a multi-DVD player (e.g. XDV-P650), select code A. When operating this unit, select code AVH.

!With this unit, code B cannot be used.

1Set the remote control selection switch on the left side of the remote control to the appropriate position with a pen tip or other pointed instrument .

!If you select AVH mode, there is no need to take the following procedure.

!If you select A/B mode, take the following procedure and change the code type to the appropriate type.

2Press 7 and 0 on the remote control si- multaneously to change the code type. Initially, the code type is set to A. Each time you press 7 and 0 simultaneously on the re-

mote control the code type switches between A and B.

Section

03

Operating this unit

En 41