MZ-N10
Power Supply Adjustment Auto Item Feed
Note : This mode is available to perform the temperature correc- tion and power supply adjustment without entering the manual mode.
• Setting method of power supply adjustment auto item feed mode.
1.Set the test mode (see page 11)
2.Press the . or [VOL
Remote commander LCD display
000 Assy**
3.Turn the jog dial (up), or press the [P MODE] key on the remote commander to set the temperature correction mode.
Remote commander LCD display
015 SetTmp @**
**: Adjusted value
5.Connect a digital voltmeter to the test points on the MAIN board, and adjust the voltage with the [VOL +] or [VOL
Press the X key to write the adjusted value, and the item number increases automatically.
6.When not writing the adjusted value, press the > key to move to the next item.
The . key is available to back to the last item.
7.The following message is displayed after all power supply ad- justments finish.
Remote commander LCD display
000 ADJ OK
8.Press the x key to return to the test mode (display check mode).
4.To change the initial value (hexadecimal), adjust with the [VOL +] or [VOL
Press the X key to write the adjusted value, and the item number increases automatically.
When not writing the adjusted value, press the > key to move to the next item.
Remote commander LCD display
741 VC1 L **
**: Adjusted value
Configuration of power supply adjustment auto item feed
000Assy ** |
The jog dial (up) or |
P MODE key on the remote |
748 REG3L2 **
015 SetTmp 19 | commander |
.
key
>
key
. key | > key |
|
749 REG3 H **
741 VC1 L ** |
.
key
>
key
. key | > key |
|
751 VREC L **
742 VC1 H ** |
.
key
>
key
. key | > key |
|
752 VREC M **
743 VC2 Lo ** |
.
key
>
key
. key | > key |
|
753 VREC H **
744 VC2 Hi ** |
.
key
>
key
. key | > key |
|
754 3.3upc **
745 REG1 ** |
.
key
>
key
. key | > | key |
|
|
755 ChgV L **
746 REG2 ** |
.
key
>
key
. key | > key |
|
756 ChgV H **
747 REG3L1 ** |
.
key
>
key
. key | > | key |
|
|
757 CIL **
> key
000 ADJ OK
22