Sears NTL19010.0 user manual Screws, and then tighten them. Be careful

Page 8

2. Attach the Upright (77) to the Base (80) with two

2

3/8" x 5 1/2" Screws (5), two 3/8" Star Washers

 

(8), and a 3/8” x 2 3/4” Screw (17) with a 3/8”

 

Star Washer (8) as shown. Start all three

77

Screws, and then tighten them. Be careful

not to pinch the Upright Wire (not shown) in

 

the Upright.

5

Attach the other Upright (not shown) as de-

 

scribed above. Note: There is not a wire on the

 

left side.

 

 

8

 

17

 

8

 

80

3. Set the Console (37) face down on a soft sur-

3

face to avoid scraching the Console. Remove

and discard the four screws (A) from the

A

Console Base Back (89). Lift off the Console

 

Base Back.

 

 

89

 

A

 

37

8

Image 8
Contents Call TOLL-FREE QUESTIONS?Model No. NTL19010.0 Serial No Table of Contents Important Precautions Page BEFORE YOU BEGIN Part Identification Chart See the inset drawing. Tie the wire tie AssemblyMake sure that the power cord is unplugged Screws, and then tighten them. Be careful Tie Pulse Wire Console Assembly Wire Tie 101 102 103 Star Washers 8. Note Start the lower Screw First Right Upright 77. Make sure that no wires areConsole Base 87. Do not overtighten Screws Upright 77. Make sure that no wires are Washers 8. Note Start the lower Screw firstAttach the Right Inside Cover and the Right Percent. Then, unplug the power cordScrews and then tighten them HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate MonitorOperation AND ADJUSTMENT HOW to Plug in the Power CordConsole DiagramFeatures of the Console HOW to Turn on the Power HOW to USE the Touch ScreenHOW to SET UP the CONSOLE  Connect to your wireless network Check for firmware updatesCalibrate the incline system Create an iFit Live accountHOW to USE the Manual Mode When you are finished exercising, remove Plug the power cord. Important If you do notKey from the console Do this, the incline trainer’s electrical compoStart the workout HOW to USE AN Onboard WorkoutSelect an onboard workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workoutHOW to USE AN Ifit Live Workout Start the workout. See onHOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode Exit the maintenance modeCalibrate the incline system of the incline trainer Find KeycodesHOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network modeHOW to USE the Stereo Sound System HOW to USE the Internet BrowserHOW to Move the Incline Trainer Troubleshooting Symptom The power turns off during useSymptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part List Qty DescriptionDescription Exploded Drawing a Exploded Drawing B 106 110 Exploded Drawing D Exploded Drawing E Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty