Star Trac E-TR manual Installing the Neck, Removing the Motor Shroud, Installing the Display

2. Installing the Neck

Remove the (4) pre-installed Socket Head Cap Screws and washers from the motor shroud end of the frame assembly. Retain the screws for use when installing the neck.

Washer

Lock Washer

Socket Head Screw

3. Removing the Motor Shroud

Remove the (4)10-24 screws securing the motor shroud to the frame assembly, and lift the motor shroud off of the frame assembly. Retain the screws for use when re-installing the motor shroud.

10-24 Screws

4. Installing the Neck

Position the bottom of the neck over the 4 threaded hole in the lower frame, an then use the 1/4” Hex Allen Key to install the (4) Socket Head Cap Screws and washers you removed earlier.

Washer

Lock Washer

Socket Head Screw

Screws Screws

5.Installing the Display

a) Use the #2 Phillips Screwdriver to remove the (4) screws that hold the back of the shroud to the display unit. Retain screws for later use. Place the back shroud aside to be installed later. Be careful not to damage the plastic.

Step 5a

12 STAR TRAC E SERIES TREADMILL OWNER’S MANUAL