Life Fitness T9i operation manual Malfunction Probable Cause Corrective Action

TROUBLESHOOTING THE TREADMILL (CONTINUED)

Malfunction	Probable Cause	Corrective Action
Striding Belt slips off-center	Uneven floor surface.	Check levelers and level tread-
		mill.
		Check striding belt & re-tension
		as necessary. Refer to Section
		6.5 “How to Adjust and Tension
		the Striding Belt.”
Maximum speed is reduced	User is pushing striding belt.	Instruct users not to push striding
	This occurs when the runner is	belt in either direction.
	running faster than the striding
	belt will travel, with the result of
	the striding belt being pushed
	with the runner’s feet.
	User is stalling striding belt.
	This will occur with heavier users
	at lower striding belt speeds. The
	striding belt will “stall” if the user
	is traveling slower than the strid-
	ing belt speed.
	Striding belt/deck malfunction.	Replace belt and deck.
	The deck laminate worn through
	or the underside of striding belt
	glazed over (hard, glossy).
	Insufficient power source.	Plug treadmill into a 15 amp. cir-
		cuit.
Rubbing sound from underneath	Foreign objects may be stuck	Inspect underneath striding belt
machine	underneath the machine.	and machine. Remove any debris
		or objects that may cause inter-
		ference with the treadmill.
	Tinsel is installed incorrectly.	Reposition tinsel on the outside
		of the striding belt.
	Insufficient power source.	Plug treadmill into a dedicated
		amp circuit.
Display does not illuminate when	Loose 10 pin connection at	Check all electrical connections
machine is powered on	display console or wax/lift control	for proper attachment.
	board.	Contact Life Fitness Customer
		Support Services*.

* See Section 6.6 “How to Obtain Product Service” for contact information.

43