NordicTrack NTL16920 user manual Troubleshooting, Problem The power turns off during use, Solution

Page 27

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-

free at 1-888-825-2588, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill

 

 

 

 

 

c

 

near the power cord. If the switch protrudes as

 

 

 

 

 

 

shown, the circuit breaker has tripped. To reset the

 

 

 

 

circuit breaker, wait for five minutes and then press

 

 

 

 

the switch back in.

 

 

Tripped

 

 

 

 

 

 

 

 

 

 

PROBLEM: The power turns off during use

Reset

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. If the treadmill still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The displays of the console do not function properly

SOLUTION:

a. Remove the key from the console and

unplug the

 

power cord.

Carefully tip the treadmill down as shown

 

in drawing a. Remove the 1” Screws (33)

and 2”

 

Screws (3) from the hood. Raise the Uprights (69) and

 

carefully remove the hood.

 

Locate the Reed Switch (10) and the Magnet (7) on

 

the left side of the Pulley (8). Turn the Pulley until the

 

Magnet is aligned with the Reed Switch.

Make sure

that the gap between the Magnet and the Reed

 

Switch is about 1/8”.

If necessary, loosen the Screw

(27)and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, making sure the screw are

in their same holes. Run the treadmill for a few min- utes to check for a correct speed reading.

a

 

 

33

69

3

 

1/8”

8

27

 

10

7

Top

 

View

 

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Customer HOT Line QUESTIONS?Table of Contents Important Precautions Never insert or drop any object into any opening Right Side Using the treadmillBefore YOU Begin Left SideExtension Legs 102 remain in the Uprights AssemblyAssembly requires two people Wire cutters Rubber malletShown Sensor Make sure that the power cord is unpluggedDo not Tighten the Bolts yet Mill to protect the floorThis product must be grounded.If it should malfunc HOW to Plug in the Power CordGrounded before using an adapter Performant LubeDetails Quire the use of the optional chest pulse sensor Features of the ConsolePulse sensor, see Them in memory for future useGetting Started HOW to USE the Manual Mode Moving your hands Distance/LapsCalories Fat calories Measure your heart rate, if desiredHOW to USE Preset Programs Select the desired preset programStart the program Measure your heart rate if desired 7When the program has ended, remove the keyNext segment Follow your progress with the displaysHOW to Create Custom Programs Select one of the custom programsPress the Start button or the Speed + button When the program has ended, remove the key HOW to USE Custom ProgramsHOW to USE Heart Rate Programs If your pulse is not detected during the program Each heart rate program is divided into several timeHOW to Connect Your Portable CD Player HOW to Connect Your Portable StereoVideocassettes Plug the adapter into an RCA Y-adapter available HOW to Connect Your Home StereoHOW to Connect Your Computer Plug the adapter into the Line OUT jack on your stereoPrograms HOW to Connect Your VCRAudio CableNext settings of the CD or video program When the CD or video program is completed,Whenkey. the program is completed, remove Follow the on-line instructions to start Program HOW to USE Programs Directly from OUR WEB SiteNext settings of the program Go to your computer and start an internet ConnectionHOW to Adjust the Cushioning System Information MODE/DEMO ModeHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHold the treadmill firmly with both hands, and lower HOW to Lower the Treadmill for USEPower cord TroubleshootingProblem The power turns off during use SolutionShifted to the left Problem The walking belt slows when walked onPower Cord If the walking belt hasExercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesQty Description Key No. Qty Key No. Qty Description Ordering Replacement PartsLimited Warranty What is COVERED-The entire NordicTrackPart No R1202A R1202A DRAWING-Model No. NTL16920Exploded DRAWING-Model No. NTL16920
Top Page Image Contents