JVC UX-F70MD manual Setting the Clock, Using Recording Timer, How Recording Timer actually works

English

There are three timers available — Recording Timer, Daily Timer, and Sleep Timer.

Before using these timers, you need to set the built-in clock.

Setting the Clock

You can set the clock whether the unit is turned on or off (on standby.)

On the remote control ONLY:

1 Press CLOCK/TIMER repeatedly until “TIME ADJUST” appears on the display.

The hour digit flashing on the display.

2 Press ¢or 4repeatedly to adjust the hour.

•When press and hold the button, the hour digit changes continuously.

3 Press SET to set the hour.

The minute digit starts flashing on the display.

Ex. When pressing SET after adjusting the hour to 10.

•If you want to correct the hour again, press

CANCEL.

The hour digit starts flashing again.

4 Press ¢or 4repeatedly to adjust the minute.

•When press and hold the button, the minute digit changes continuously.

5 Press SET to finish setting the clock.

The built-in clock starts.

Ex. When pressing SET after adjusting the minute to 10.

Using Recording Timer

With Recording Timer, you can make an unattended recording.

•You can set Recording Timer whether the unit is turned on or off (on standby.)

•To correct a mis-entry any time during the setting process, press CANCEL.

How Recording Timer actually works

The unit automatically turns on, and starts recording on an MD or a tape when the timer-on time comes. Then, when the timer-off time comes, the recording stops and the unit automatically turns off (on standby).

Recording Timer works only once, but the timer settings remain stored in memory until you reset them or unplug the AC power cord.

On the remote control ONLY:

1 Press CLOCK/TIMER repeatedly until “REC TIMER” appears on the display.

The timer ( ) indicator lights, and the REC indicator starts flashing on the display.

•Each time you press the button, the timer mode changes as follows:

REC TIMER DAILY TIMER

Clock Time TIME ADJUST

2 Press 4to select “ON,” then press SET.

REC

	3 Select the source to record.
To adjust the clock again		1) Press ¢or 4repeatedly to select the source.
Press CLOCK/TIMER repeatedly in step 1 until “TIME ADJUST”		• Each time you press the buttons, the source changes
appears on the display, then perform steps 2 to 5 above.		as follows:
When you unplug the AC power cord or if a power			FROM AUX		FROM FM
				FROM AM
failure occurs		2) Press SET.
The clock setting will be reset to “0:00.” If this happen, you need
		• When you select “FROM FM” or “FROM AM,”
to set the clock again.
		select a preset number by pressing ¢ or 4.
		• When you select “FROM AUX,” the external
To check the clock time by sound while the unit is		equipment also need to have the timer function.
turned off (on standby)
Press DIMMER while the key-touch tone is set to on. The clock		3) Press SET again.
time will be indicated by sound.
– 57 –