12.Attach the ground wire on the Upright Wire (28) to the indicated hole in the Base (48) with a #8 x 1/2" Ground Screw (11).
Press the indicated grommet into the Right Upright (36).
Raise the Uprights (31, 36).
13.Attach the Latch Housing (30) to the Left Upright (31) with two #10 x 1" Tek Screws (27). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Screws.
Locate the Latch Pin Assembly (29). Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (30), and tighten the knob back onto the pin.
12 |
| Grommet | 36 |
|
| 28 | |
| 48 |
| |
|
|
| |
| Hole |
|
|
| Ground |
|
|
| Wire | 11 |
|
|
|
|
13 | 30 |
|
|
Knob |
|
| |
| Large |
| |
27 | Pin | Hole | 31 |
Spring |
| ||
Collar | 29 |
|
|
14.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 24). To protect the floor or carpet, place a mat under the treadmill.
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1. | Make sure that the power cord is unplugged. |
|
|
|
| Remove the indicated #8 x 3/4" Screw (2) and the |
|
| 26 |
2. | Access Door (6) from the Console Base (26). |
|
| |
Connect the wire on the receiver (A) to the indicated |
|
|
| |
| wire extending from the Console Base (26). Hold the |
|
|
|
| receiver so that the small cylinder is oriented as |
|
|
|
| shown and is facing the Console Base. Attach the | Small |
| |
| receiver to the plastic posts on the Access Door (6) | Wires | ||
3. | with the two included small screws. | Screws | ||
Make sure that no wires are pinched. Reattach the | Small |
|
| |
| Access Door (6) with the #8 x 3/4" Screw (2). Discard | Cylinder |
| A |
| the other wires included with the receiver. | 6 | 2 | |
|
|
| ||
|
|
|
| |
11