| 27 |
| 58 |
60 | 59 |
57 |
|
56 | 47 |
| |
| PUSH/PULL |
| CABLE |
FIGURE 20 |
|
STEP 20
•Insert the PUSH/PULL CABLE through the bottom of the PRESS ARM (27) up to the CONTROL LEVER (60) and hold in place with one
•SECURELY assemble the PUSH/PULL CABLE to the CONTROL LEVER (60) using one 3/8” JOINT CONNECTOR CAP (57), two #10 FLAT WASHERS (59), and two
•Slide one 4” VINYL SLEEVE (47) over the CONTROL LEVER (60). Then SECURELY assemble the CONTROL LEVER (60) to the TAB on the PRESS ARM (27) using one 3/8” JOINT CONNECTOR CAP (57), two #10 FLAT WASHERS (59), and two
| 1/2 |
| 1/2 |
| 1/2 |
| 1/2 |
| 1/2 |
|
| 1/2 |
0 | 1 | 2 | 3 | 4 | 5 | 6 | ||||||
19