ParaBody 425104 manual Button

Page 24

17

4

25

8

92

46

96

BUTTON

HEAD

18

1

FIGURE 27

STEP 26

SECURELY assemble one 3/8” X 1” BUTTON HEAD CAP SCREW (96) and one 3/8” LOCK NUT (92) to the last hole on the BACK PADADJUST (16). See FIGURE 27.

SECURELY insert one 2” SQ. END CAP (46) to the open end of the BACK PAD ADJUST (16). See FIGURE 27.

SECURELY tighten all loose frame connections made to this point. (!!! IMPORTANT !!! to assure proper function of the 425, the loose frame connections must be tightened in the following order) Tighten the:

MIDDLE UPRIGHT (8) to the BASE (1) and to the TOP BOOM (17).

REAR UPRIGHT (4) to the BASE (1) and to the TOP BOOM (17).

PRESS BASE (18) to the REAR (4) and MIDDLE UPRIGHTS (8).

PRESS BASE (18) to the BASE (1).

FRONT UPRIGHT (25) to the BASE (1).

NOTE: DO NOT TIGHTEN THE FRONT UPRIGHT TO THE TOP BOOM AT THIS TIME.

24

Image 24
Contents Home GYM Important Notes Parts List Step 87 1/2 X Hexnut Step 84 3/8 X Step 88 1/2 X X 3 108108 3/8 HEX NUT Step 83 3/8 X 1-1/4 Step Step Step Step LOW Height NUT PUSH/PULL Underside Justment Tube 22 to rotate freely LOW Height NUT Detail Button Cable has been routed 90 1/2 X 3-1/2 Post Detail Support Tube to rotate freely Hexnut Page 102 Cable Installation 100 Cable LAT PEC Cable See Detail 83 3/8 Legext Cable LAT Cable Press Step Legext Press Cable LEG Cable 105 96 3/8 X 1 Button Head CAP Screw Step