ParaBody 425104 manual Detail

	23
38
12
91
3/8 X 2-3/4” 85
	61
		63
	51	108
		64 3/8 X 2-1/2” SOCKET
		HEAD CAP SCREW
	3/8” HEX NUT 108	DETAIL 32
	63
FIGURE 32
	64 3/8 X 2-1/2” SOCKET HEAD CAP SCREW

STEP 32

•SECURELY assemble one 3/8” SPRING PIN (51) to the spring pin housing of the PRESS BACK SUPPORT (23). (NOTE: Tighten the nut of the SPRING PIN ASSEMBLY SECURELY.)

•Assemble one 3-PRONG KNOB (61) the PRESS BACK SUPPORT (23) as shown in FIGURE 32.

•SECURELYassemble two 3” WHEELS (63) using two BLACK 3/8 X 2-1/2” SOCKET HEAD CAPSCREWS (64) and two 3/8” HEX NUTS

(108)as shown in DETAIL 32.

•SECURELY assemble two wheel assemblies to the PRESS BACK SUPPORT (23) as shown in FIGURE 32.

•SECURELY assemble the SEAT PAD (38) to the PRESS SEATADJUST (12) using two 3/8 X 2-3/4” BOLTS (85) and two 3/8” WASHERS

(91).See FIGURE 32.

•Pull back the 3/8” SPRING PIN (51) on the PRESS BACK SUPPORT (23) and slide the PRESS SEAT ADJUST (12) into the receiving well. Engage the 3/8” SPRING PIN (51) into one of the adjustment holes.

28