ParaBody 425104 manual Justment Tube 22 to rotate freely

62

96 3/8 X 1”

BUTTON HD CAP SCREW

3

13	95 LOW
	HEIGHT
	NUT	78

22

62

1/2 X 3-1/2” 90

FIGURE 22

STEP 22

•Attach eight PARAGLIDE STRIPS (62) INSIDE the end of the RECEIVING TUBE (13) and four PARAGLIDE STRIPS (62) to the OUTSIDE of the PRESS ADJUSTMENT TUBE (22) using the following steps:

•Thoroughly clean all sufaces where PARAGLIDE STRIPS (62) are to be attached.

•Remove the PARAGLIDE STRIPS (62) from the paper backing and firmly apply them to surfaces. (NOTE: Orientate the strips so they will slide by each other.)

•CAREFULLY slide the PRESS ADJUSTMENT TUBE (22) into the RECEIVING TUBE (13). (NOTE: Make sure the spring pin barrel on the RECEIVING TUBE (13) is on the same side as the holes in the PRESS ADJUSTMENT TUBE (22).)

•Thread one 3/8 X 1” BUTTON HEAD CAP SCREW (96) through the slot in the RECEIVING TUBE (13) and into the ADJUSTMENT TUBE (22)

•Insert two 1/2” FLANGE BEARINGS (78) into the COUNTER LEVER (3) as shown in FIGURE 22.

•Assemble the PRESS ADJUSTMENT TUBE (22) to the COUNTER LEVER (3) using one 1/2 X 3-1/2” BOLT (90) and one 1/2” LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the PRESS AD-

JUSTMENT TUBE (22) to rotate freely.)

21