ParaBody 425104 manual Detail

27	13	PUSH/PULL
		CABLE
DETAIL
23		1/4” NUTS
		DONOTOVERTIGHTEN!
	SPRING PIN
	ASSEMBLY
FIGURE 25 13		DETAIL 25

STEP 23

•SECURELY assemble the SPRING PIN ASSEMBLY of the PUSH/PULL CABLE to the SPRING PIN BARREL on the RECEIV-

ING TUBE (13). (!!! IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLY SECURELY)

•Swing the PRESS ARM (27) up until the SPRING PIN of the PUSH/PULL CABLE engages in one of the adjustment holes.

•Thread the second 1/4-28 IN. NUT onto the threaded end of the CABLE, and cinch the two 1/4-28 IN. NUTS around the flat. (IMPOR-

TANT!DONOTOVERTIGHTENNUTS!)

•Use the extra thread on the end of the CABLE to adjust out slack. ( !!! DO NOT ADJUST OUT TO FAR !!! ALWAYS ALLOW SPRING PIN ASSEMBLY TO FULLY ENGAGE)

				STEP 26
3/8 X 1-1/4” 83				• SECURELY assemble the SEAT PAD (40) to the
		91		BACK PAD ADJUST (16) using four 3/8 X 1-1/4”
		16	40	BOLTS (83) and four 3/8” WASHERS (91). See
				FIGURE26.
25				• SECURELY assemble one 3/8” SPRING PINASSEM-
				BLY (51) to the FRONT UPRIGHT (25) as shown in
51
				FIGURE26.
				• Attach one 3-PRONG KNOB (61) the FRONT UPRIGHT
				(25) as shown in FIGURE 26.
61				• Insert the SEAT PAD (40) & BACK PAD ADJUST
				(16) into the FRONT UPRIGHT (25) while pulling back
				on the SPRING PIN ASSEMBLY (51) until it engages
				in one of the adjustment holes. See FIGURE 26.
FIGURE 26
1/2	1/2	1/2	1/2	4	1/2	1/2
0	1	2	3		5	6
			23