| 48 |
76 | 107 |
78 |
|
27 | 8 |
| |
| 4 |
FIGURE 23 |
|
STEP 23
•Insert two 3/4” FLANGE BEARINGS (76) into the PRESS ARM (27) as shown in FIGURE 23.
•Hold the PRESS ARM (27) between the REAR (4) and MIDDLE UPRIGHTS (8) and slide the 3/4 DIA X 11” SHAFT (107) throught the MIDDLE UPRIGHT (8), PRESSARM (27), and through the collar on the REAR UPRIGHT (4). To SECURE the SHAFT (107) in place, insert two 5/16” SET SCREWS (48) into the collars on the UPRIGHTS and tighten. See FIGURE 23.
•Insert two 1/2” FLANGE BEARINGS (78) into the PRESS ARM (27) as shown in FIGURE 23.
| 95 LOW HEIGHT NUT |
27 |
|
| 87 1/2 X 3” |
FIGURE 24 | 13 |
| |
STEP 24 |
|
•Assemble the RECEIVING TUBE (13) to the PRESS ARM (27) using one 1/2 X 3” BOLT (87) and one 1/2” LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the PRESSARM (2) to rotate freely.) See FIGURE 24.
22