HOW to USE a Preset Workout

1. Press any button on the console or begin ped- aling to turn on the console.

When you turn on the console, the displays and the target pacer coach will light. A tone will then sound and the console will be ready for use.

2. Select a preset workout.

To select one of the four preset workouts, press the Weight Loss, the Aerobic 1, the Aerobic 2, or the Performance button on the left side of the con- sole.

When you select a preset workout, the number of the workout and the maximum resistance level will appear in the displays for a few seconds. A profile of the resistance levels of the workout will also scroll across the left display.

3. Begin pedaling to start the workout.

Each workout is divided into 30 one-minute seg- ments. One resistance level and one target pace setting is programmed for each segment. Note:

The same resistance level and/or target pace set- ting may be programmed for consecutive seg- ments.

During the workout, the workout profile will show your progress (see the drawing above). The flash- ing segment of the profile represents the current segment of the workout. The height of the flashing segment indicates the resistance level for the cur- rent segment. At the end of each segment of the workout, a series of tones will sound and the next segment of the profile will begin to flash. If a differ- ent resistance level is programmed for the next segment, the resistance level will appear in the display for a few seconds to alert you. The resis- tance of the pedals will then change.

During the workout, the target pacer coach will prompt you to keep your pedaling pace near the target pace setting for the current segment. When a left indicator lights, increase your pace; when a right indicator lights, decrease your pace. When the center indicator lights, maintain your current pace. IMPORTANT: The target pacer coach is intended only to provide a goal. Make sure to pedal at a pace that is comfortable for you.

If the resistance level for the current segment is too high or too low, you can manually override the resistance level by pressing the Quick Resistance buttons. However, when the current segment ends, the resistance of the pedals will automatical- ly adjust to the resistance level for the next seg- ment.

If you stop pedaling for several seconds, a series of tones will sound and the workout will pause. To restart the workout, simply resume pedaling. The workout will continue until the last segment of the workout ends.

4.Follow your progress with the displays. See step 4 on page 17.

5.Measure your heart rate if desired. See step 5 on page 18.

6.Turn on the fan if desired. See step 6 on page 18.

7.When you are finished exercising, the console will turn off automatically.

See step 7 on page 18.