3.Align dimple of middle pole with slot of bottom pole.While maintaining alignment, bounce top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no longer move toward pole identification mark.
CAUTION!
THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A
BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.
5"
Bottom Pole
IDENTIFICATION
STICKER
NOTE:
POLE SECTIONS SHOULD HAVE A 3-1/2" (9 CM)
MINIMUM
OVERLAP.
POLE
IDENTIFICATION
MARK
1
2
3
IDENTIFICATION | ||
Bottom Pole | ||
STICKER | ||
|
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH
THE HARDWARE
IMPORTANT!
WOOD SCRAP
(NOT SUPPLIED)
Holes in top (1) and bottom (3) pole sections MUST align to correctly position elevator system toward playing surface.
ID# | M601114 | 8/05 | 10 |