Spalding M661154 manual 08/05

Page 21

10.Support pole on sawhorse. Attach backboard assembly to top pole section (4) as shown. Install pole cap (25).

21

20

34

1

21 32

25

20	32
20
	49
	34
57

11.Install upper elevator tubes (33) to triangle plates (63) as shown. Install handle assembly to lower elevator tubes (34) using bolt (57), spacers (20), and nut (21) as shown.

58

1

NOTE:

Before going on to next step, set adjustable system assembly to the 10’ (3.05 m) setting.

20 21

20

34

57

57

21

33

20

34

32

34

20

33

21

08/05

ID#

M601114

Image 21

Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back ID# Parts List See Hardware IdentifierHardware Identifier Plastic Spacers & Caps Item #61 Item #62 Item #63 Item #64 Item #65 Item #66 Pole Sections Should have aOverlap Pole Sections should have a 3-1/2 9 CM Minimum Overlap AND/OR Do not Over Tighten ID# ID# AND/OR Tighten just until washers 50 stop moving FIG. a ID# Toward Board Upper Elevator tube Lower Elevator tube Pole ID# 08/05 Bracket OrientationInstall net Fill Base FIG. a Cover Section G Height Adjustment and Moving Label Avertissement Warnung ¡ADVERTENCIA Manuel dutilisationOutils ET Matériel Requis ID# Achtung Consignes DE Sécurité ¡IMPORTANTE WichtigCerceau Korbrand Borde Français Liste DES Pièces TeilelisteLista DE Piezas #14 #30 #21 #31 #11 #47 #50 #10 #43 Identificadores DEL Herraje Espaciadores DE Plástico Y Tapas Section a Montage DES Sections DE Poteau Centrale Inférieure Mitte Unten Media InferiorRemarque ID# Wichtig ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA ID# UND/ODER ET/OU Wichtig ¡IMPORTANTE FIG. a ABB. a DIE Korrekte Ausrichtung Beachten ID# ID# Remarque Hinweis / Nota Installez le cerceau Slam Jam sur le panneau ID# Remarque Hinweis Nota Avertissement Warnung ¡ADVERTENCIA FIG.A ABB. a Protection / Abdeckung / Cubierta Réglage DE LA Hauteur Höhenverstellung Ajuste DE LA Altura