Spalding M661154 manual Orientation, Bracket

Page 22

12.
	Install Rim to Backboard

A.Fit rim (67) securely into bracket (61) as shown. Allow T-bolt (66) to slip through center hole in rim (67).

B.Install reinforcement bracket (62) onto T-bolt (66) as shown.

C.Install spring (64) onto T-bolt (66) as shown.

D.Install special nut (65) and washer (63) onto T-bolt (66).

E. Tighten special nut (65) until flush with end of T-bolt (66).

A.	B.
	62
67	66
	66
	66
	61
	65

63

C.D.

64

66

NOTE:

ORIENTATION

OF BRACKET

62

			66	63
			66
			E.
			65
ID#	M601114	8/05		22

Image 22

Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back Parts List See Hardware Identifier ID#Hardware Identifier Plastic Spacers & Caps Item #61 Item #62 Item #63 Item #64 Item #65 Item #66 Should have a Pole SectionsOverlap Pole Sections should have a 3-1/2 9 CM Minimum Overlap AND/OR Do not Over Tighten ID# ID# AND/OR Tighten just until washers 50 stop moving FIG. a ID# Toward Board Upper Elevator tube Lower Elevator tube Pole ID# 08/05 Orientation BracketInstall net Fill Base FIG. a Cover Section G Height Adjustment and Moving Label Manuel dutilisation Avertissement Warnung ¡ADVERTENCIAOutils ET Matériel Requis ID# Achtung Consignes DE Sécurité Wichtig ¡IMPORTANTECerceau Korbrand Borde Liste DES Pièces Teileliste FrançaisLista DE Piezas #14 #30 #21 #31 #11 #47 #50 #10 #43 Identificadores DEL Herraje Espaciadores DE Plástico Y Tapas Centrale Inférieure Mitte Unten Media Inferior Section a Montage DES Sections DE PoteauRemarque ID# Wichtig ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA ID# UND/ODER ET/OU Wichtig ¡IMPORTANTE FIG. a ABB. a DIE Korrekte Ausrichtung Beachten ID# ID# Remarque Hinweis / Nota Installez le cerceau Slam Jam sur le panneau ID# Remarque Hinweis Nota Avertissement Warnung ¡ADVERTENCIA FIG.A ABB. a Protection / Abdeckung / Cubierta Réglage DE LA Hauteur Höhenverstellung Ajuste DE LA Altura