Spalding M661154 manual Id#

Page 14

5.Insert axle (5) through wheel bracket (4). Secure wheels (6) to axle using pushnuts (7). Carefully tap pushnuts onto axle with hammer or mallet

IMPORTANT!

SIDE OF WHEEL WITH LONGER PLASTIC AXLE NEEDS TO FACE THE WHEEL BRACKET.

6

6 5 4

7

7

6.Install wheel assembly to base (8) using bolts(9), washers(10) and nuts (11) as shown.

8

9

10

10

11

ID#

M601114

8/05

14

Image 14

Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back Parts List See Hardware Identifier ID#Hardware Identifier Plastic Spacers & Caps Item #61 Item #62 Item #63 Item #64 Item #65 Item #66 Overlap Pole SectionsShould have a Pole Sections should have a 3-1/2 9 CM Minimum Overlap AND/OR Do not Over Tighten ID# ID# AND/OR Tighten just until washers 50 stop moving FIG. a ID# Toward Board Upper Elevator tube Lower Elevator tube Pole ID# 08/05 Orientation BracketInstall net Fill Base FIG. a Cover Section G Height Adjustment and Moving Label Manuel dutilisation Avertissement Warnung ¡ADVERTENCIAOutils ET Matériel Requis ID# Achtung Consignes DE Sécurité Wichtig ¡IMPORTANTECerceau Korbrand Borde Liste DES Pièces Teileliste FrançaisLista DE Piezas #14 #30 #21 #31 #11 #47 #50 #10 #43 Identificadores DEL Herraje Espaciadores DE Plástico Y Tapas Centrale Inférieure Mitte Unten Media Inferior Section a Montage DES Sections DE PoteauRemarque ID# Wichtig ¡IMPORTANTE Avertissement Warnung ¡ADVERTENCIA ID# UND/ODER ET/OU Wichtig ¡IMPORTANTE FIG. a ABB. a DIE Korrekte Ausrichtung Beachten ID# ID# Remarque Hinweis / Nota Installez le cerceau Slam Jam sur le panneau ID# Remarque Hinweis Nota Avertissement Warnung ¡ADVERTENCIA FIG.A ABB. a Protection / Abdeckung / Cubierta Réglage DE LA Hauteur Höhenverstellung Ajuste DE LA Altura