Star Trac S-UB UPRIGHT BIKE manual Series Recumbent Bike Assembly and Setup, Unpacking

S SERIES RECUMBENT BIKE

ASSEMBLY AND SETUP

Use the following procedures to unpack and assemble your STAR TRAC S-

RB / S-RBx RECUMBENT BIKE.

UNPACKING

NOTE: Complete unpacking instructions are printed on the side of the shipping carton.

Turn the shipping carton upside-down, and fully open all four flaps on the bottom of the carton.

Turn the shipping carton right-side up, then lift the carton off of

the foam inserts. Remove all parts and foam inserts, and verify that the following parts are included in your shipment:

Description	Qty
Bike Frame	1
Display Console Assembly	1
Seat Frame Assembly	1
Front Foot	1
Rear Foot	1
Pedals (set of two)	1
Screw, Button Head, M10 X 30	8
Screw, Flat Head, M6 X 16	4
Screw, Socket Head, M6 X 20	4

TOOLS REQUIRED

Most STAR TRAC bikes can be assembled using the following tools:

n Metric Hex Key Wrenches		n
n	Metric Open-End Wrenches	n
n Metric Ratchet Socket Wrench Set		n
n	Torque Wrench	n

Channel Lock Pliers

Vice Grip Pliers

Rubber Mallet

Phillips Head Screwdriver

Your STAR TRAC S-RB /S-RBx RECUMBENT BIKE includes a hex key set and combination open-end wrench.

ASSEMBLY

1. Install the Front Foot

NOTE: The front foot assembly has wheels attached to the front edge. Be sure the wheels face forward when installing the front foot assembly.

STAR TRAC S SERIES BIKES OWNER’S MANUAL 15