Star Trac S-RB RECUMBENT BIKE manual Install the Rear Foot, Install the Display Console

Page 13

2. Install the Rear Foot

Lift up the rear of the bike frame and place the rear foot assembly in position under the frame, aligning the holes in the foot with the holes in the frame.

Using four M10 X 30 button head screws, secure the rear foot assembly to the frame. Tighten all four screws securely.

3. Install the Display Console

NOTE: It is necessary to have one person support and position the display console while a second person makes the cable connections.

Carefully pull the cable bundle out of the lower neck on the bike frame. Use a pair of wire cutters or other suitable tool to cut and remove the tie wrap from the cable bundle.

Hold the display console neck approximately one inch from the neck brackets of the bike frame. Plug the display console power, main I/O and Coax cable into their mating connectors in the display console neck.

NOTE: The power connector is a “loose” fit. A strip of electrical tape for securing the power connector is provided inside the lower neck on the bike frame.

While holding the power cable connectors together, make a small “bundle” of the cable, and wrap with electrical tape to prevent the connectors from separating.

CAUTION: Be careful not to pinch your fingers between the console neck and the bike frame when sliding the console into place.

STAR TRAC S SERIES BIKES OWNERS MANUAL

Step 2

Step 3a

Step 3b

Step 3c

13

Image 13
Contents N E R ’ S M a N U a L Table of Contents Page Upright Bike Recumbent Bike About this Manual IntroductionPrecautions Safety InstructionsDo Not Waarschuwing VeiligheidsinstructiesConsignes DE Securite Mise EN GardeWarnung SicherheitsvorschriftenInstruzioni DI Sicurezza AttenzioneAdvertência Instruções DE SegurançaInstrucciones DE Seguridad AdvertenciaRåd Chinese Safety Instructions HereAdvarsler Japanese Safety Instructions Here Series Upright Bike Assembly and Setup Assembly and SetupAssembly UnpackingInstall the Display Console Install the Rear FootInstall the Pedals Install the Seat PostLeveling the Bike Series Recumbent Bike Assembly and Setup Install the Rear Foot Install the Seat Frame Adjusting Seat Height S-UB / S-UBx Upright Bike Seat AdjustmentsAdjusting Seat Position S-RB / S-RBx Recumbent Bike Operating InstructionsPedal Strap Operation Display Panel FeaturesHints and Tips for Getting Started Using the Personal FANCooldown Cycle To operate the bike during CooldownLockout ID Processing Heart Rate MonitoringContact Heart Rate Monitoring Chest Strap Heart Rate MonitoringQuick Start Preset ProgramsManual Program To operate the Quick Start programTo operate the Burn Calories program Burn Calories ProgramTo operate the Increase Endurance program Increase Endurance ProgramHeart Rate Control Programs Advanced Workouts ProgramsTo operate the Constant Heart Rate Control program Heart Rate Training Range Upper Level ProgramHeart Rate Training Range Lower Level Fitness Test Burn FAT ProgramTo operate the Burn FAT Control program To operate the Fitness Test program Goal WorkoutsTo operate the Calorie Goal program To operate the Distance Goal program Auto Pilot ProgramTo operate the Auto Pilot program Daily Maintenance Preventative MaintenanceWeekly Maintenance Monthly Maintenance Manager / Maintenance ModeManager Mode Maintenance Mode LOE OFF START-UP Service Messages TroubleshootingRegulatory Information Star Trac