A S S E M B LY STEP 4 |
|
|
|
| UPPER HANDLEBAR |
| NOTCH |
|
|
| |
CONSOLE MAST | TAB | SET SCREWS |
|
| |
|
| BOLT & WASHER |
| LOWER HANDLEBAR |
|
NOTE: There is NO hardware bag for this step. All hardware is
A)Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by
C)Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using
|
| After handlebars are assembled they will rotate freely – be cautious. Until the |
| WARNING | |
| machine is fully assembled, do not grab the handlebars for support. | |
|
|
|
|
|
|
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
TROUBLESHOOTING CONDITIONING & MAINTENANCE GUIDELINES
11
LIMITED WARRANTY