Precor C936i owner manual Hardware KIT, Additional Tools Needed

C O M M E R C I A L P R O D U C T S D I V I S I O N

HARDWARE KIT

After unpacking the treadmill, open the hardware kit (refer to Diagram 2) and make sure that you have the following items:

❑(A) four 2-inch long socket head screws — mount upright supports to base

❑(B) four barrel spacers — place on 2-inch screws

❑(C) ten ¾-inch long socket head screws

❑(D) sixteen flat washers

❑(E) two 1¼-inch socket head screws — handrail clamp assembly

❑(F) four large diameter washers — place on handrail end cap screws

❑(G) four 1-inch socket head screws — handrail mounting bracket

❑(H) ¼-inch hex key — 3 inches by 10 inches

If any items are missing, refer to Obtaining Service on page 7.

Note: After assembling the treadmill, you will have four ¾-inch long socket head screws (C) and two flat washers (D) remaining.You can discard them if you wish. Also, be sure to store the hex key in a secure place. It is used for specific main- tenance procedures that are described in the manual.

Diagram 2 Hardware kit.

A C E G

B

D

F

H

ADDITIONAL TOOLS NEEDED

Obtain the following tools before assembling the treadmill.

❑	Wire cutter	❑	½-inch box end wrench
❑	Bubble level	❑	String

page 10