Precor C936i owner manual Quickstart DefaultValues, Prompts Default Value

Page 34

C O M M E R C I A L P R O D U C T S D I V I S I O N

QUICKSTART: This key lets the user bypass the Setup prompts and start working out immediately using the Manual program. Default values apply.

QUICKSTART DefaultValues

Prompts Default Value

PROGRAM Manual

TIME	Club dependent (usually 30 minutes - see page 25.)
WEIGHT	150 lbs. (68 kg.)
AGE	0 : A valid AGE must be entered to utilize the SmartRate®
	display. If QUICKSTART is pressed after an AGE is entered,
	then the SmartRate display will appear when a user wears the
	chest strap or grasps the touch-sensitive handrail grips. If no
	AGE entry occurs, then SmartRate LED’s light, but are not acti-
	vated. Note that the chest strap is available through a Precor
	dealer. Refer to Obtaining Service on page 7.

The QUICKSTART key can be pressed any time during the Setup prompts. For more information, refer to page 30, The Setup Mode and the QuickStart Feature.

ENTER: Workout specific prompts which appear on the display need to be addressed and then “entered” into the unit's memory by pressing the ENTER key. Refer to Quick Steps to Working Out on page 37.

SPEED ▼▲: During a workout, the SPEED keys let the user decrease or increase the running belt’s speed. The display can show a range from 0.5 to 11 miles per hour (1 to 18 kilometers per hour) and changes can be made in 0.1 increments from 1 to 11 mph (1 to 18 kph). The display indicates a speed of “0” when a user presses the SPEED ▼ key to stop the running belt.

Any time during a workout, the user can view the actual speed by lightly tapping either SPEED ▼ or ▲ key. His or her “pace” (minutes per mile or kilometer) appears in the left-most portion of the display. To change the speed, a user can hold the key down for more than two seconds.

During Setup mode, the SPEED ▼▲ keys are used for data selection. Pressing either ▼ or ▲ key changes what appears on the display, but does not affect the speed of the running belt. Refer to Setup Mode and Prompts on page 29.

page 34

Image 34

Contents M M E R C I a L P R O D U C T S D I V I S I O N Important Safety Instructions Safety Approval Grounding InstructionsTable of Contents Maintenance Exercising on the TreadmillEuropean Applications Radio Frequency Interference RFIVoid the user’s authority to operate the equipment Obtaining Service About this ManualM M E R C I a L P R O D U C T S D I V I S I O N Standard Equipment Unpacking the TreadmillOther Equipment Hardware KIT Additional Tools NeededInstallation Requirements Setting Up the TreadmillAssembly Instructions Diagram Route cable Secure the display console to the upright supports. Diagram CsafeDiagram Attach handrails to the side and base brackets. Diagram Perform steps a. and b. on the opposite sideTest the heart rate feature. Diagram Install handrail First Tighten Level Unit Turning the Unit on and OFF Checking the Alignment of the Running Belt If the running belt ThenChanging the Club Settings Club InformationDisplay key functions within the Club Custom Mode Determining the Units of MeasureDetermining the Club Speed Limit Setting a Workout Time LimitSetting a Pause Time Limit To 18 kphM M E R C I a L P R O D U C T S D I V I S I O N Using Csafe Standard Equipment User ID Entry Program KeysFeatures on the Display Console C936i DisplaySetup Mode and Prompts Smartrate DisplayPress Quickstart at Setup Mode and the Quickstart FeatureWeight prompt Following occurs Precor bannerDisplay Features During a Workout M M E R C I a L P R O D U C T S D I V I S I O N Keys on the Display Console Keypad keysQuickstart DefaultValues Prompts Default ValueChanging the Display Features Using the Select KEY Using the Heart Rate Touch Capability Using the Security ClipUsing the Handrails Exercising on the TreadmillWorkout Tips Keypad TipsQuick Steps to Working OUT Continue your workout Cooling Down After a Workout Red Stop buttonPAUSE, Workout SUMMARY, and Exit Features StopUsing the Smartrate Feature Heart Rate FeaturePrograms Manual Mode and the Quickstart KEY 200 190 180 170 160 150 140 130 120 110 100Interval Program Cross Country ProgramTo use the interval program, take the following steps Weight Loss Program Random ProgramHeart Rate Program Inspection MaintenanceCleaning the Equipment Perform a daily inspection of the treadmillAligning the Running Belt Servicing the Treadmill Storing the Chest StrapLong Term Storage Thank You and Welcome to Precor Please indicate the type and number of products purchased Date of Purchase Purchased from Dealer nameProduct Serial Numbers How many members do you have?Conditions and Restrictions Limited WarrantyWarranty Periods and Coverage Complete this portion and keep for your recordsProduct Specifications Electronic Specifications