Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied for the DVD player.

•The following operations are only possible when the receiver is ready for the main room operations, and are used only for the main room source—DVD MULTI.

Activating the DVD MULTI Playback Mode

Perform the basic settings and adjustments using the Setup and Adjustment Menus first (see pages 33 to 45).

Activating DVD MULTI playback mode automatically recalls the memorized settings and adjustments done on the above menus.

•You also need to set the DVD player to the analog discrete output mode.

IMPORTANT:

Check to see if the following before or while using the buttons and controls.

Before you start, remember...

•Make sure that you have connected the DVD player to the analog discrete input (5.1 CH reproduction) jacks on the rear (see page 13).

•When the SUB ROOM speaker indicator is lit on the display, the DVD MULTI button does not work.

1.Press DVD MULTI so that “DVD MULTI” appears on the display.

DVD MULTI

For the main room operations:

The MAIN ROOM ON/OFF lamp on the unit is lit.

•When using the unit:

– “SUB ROOM” is not shown in the main display.		DOOR
		DOWN
– Press DOOR DOWN to use the buttons inside the
front door.
To close the front door, press DOOR UP.
• When using the remote control:
– Set the MAIN ROOM/SUB ROOM (LEARN/
TRANSMIT) selector to “MAIN ROOM.”
– Check the indication shown on the remote’s	LEARN TRANSMIT
– Check the indication shown on the remote’s
display when you press a button on the remote
control—this indicates the remote control
control—this indicates the remote control	MAIN ROOM SUB ROOM

operation mode together with multi-room

operation mode (either MAIN ROOM or SUB ROOM) for a while (10 or 5 seconds.)

LEARN TRANSMIT

	STANDBY	ON
MAIN ROOM SUB ROOM
MAIN ROOM	SUB ROOM TV/CATV/DBS	VCR 1
ON/OFF	ON/OFF
	STANDBY/ON	STANDBY/ON

MAIN ROOM

Ex. When you press DVD MULTI with

MAIN ROOM/SUB ROOM (LEARN/TRANSMIT) selector set to “MAIN ROOM.”

On the unit	On the remote control
(inside the front door)

Note:

When you select “DVD MULTI” as the main room source to play, the THX ON/OFF, SURROUND ON/OFF and DSP MODE buttons do not work.

2.Select the analog discrete output mode on the DVD player, and start playing a DVD.

• Refer to the manual supplied with the DVD player.

If you want to modify the stored sound adjustments temporarily

See “Adjusting Surround Sounds Temporarily” on page 49.

•When adjusting the sounds for the DVD MULTI playback mode, you cannot output the test tone.

•If “L/R” is selected on the SURROUND SPEAKERS submenu (see page 38), you cannot adjust the output levels of the surround back speakers.