JVC RX-DP10VBK manual Setting the Speakers —SPEAKERSETTING, Lsb Rsb, 7For subwoofer, Notes

Setting the Speakers —SPEAKER SETTING (1)

Setting the Speaker Distance —SPEAKER DISTANCE (2)

SPEAKER SETTING ￿

￿ ￿
￿ SUBWOOFER	: NO￿
FRONT SP	: LARGE￿
CENTER SP	: SMALL￿
SURROUND SP	: SMALL￿
SURR BACK SP	: SMALL
	:OPERATE￿
	:BACK

7For subwoofer:

Select one of the following.

To obtain the best possible surround sound of the Surround and DSP modes in the main room, you have to register the information about the speaker arrangement after all connections are completed.

SPEAKER DISTANCE ￿			The distance from your listening
			point to the speakers is another
￿ ￿
￿ UNIT	: meter￿		important element to obtain the
SUBWOOFER	: 3.00m￿
FRONT L SP	: 3.00m￿		best possible surround sound of
FRONT R SP	: 3.00m￿
CENTER SP	: 3.00m￿		the Surround and DSP modes.
SURR L SP	: 3.00m￿		You need to set the distance from
SURR R SP	: 3.00m￿
SBACK L SP	: 3.00m￿		your listening point to the
SBACK ￿R SP	: 3.00m
:OPERATE		:BACK	speakers.

By referring to the speaker distance setting, this unit automatically sets the delay time of the sound through each speaker so that sounds through all the speakers can reach you at the same time.

YES	: Select this when a subwoofer is connected.
NO	: Select this when no subwoofer is used.

7For front speakers, center speaker, surround speakers, and surround back speakers:

Select one of the following.

LARGE : Select this when the speaker size is relatively large.

SMALL : Select this when the speaker size is relatively small.

NONE : Select this when you have not connected a speaker. (Not selectable for the front speakers)

Notes:

•Keep the following comment in mind as reference when adjusting.

–If the size of the cone speaker unit built in your speaker is greater than 12 cm (4 3/4 inches), select “LARGE,” and if it is smaller than 12 cm (4 3/4 inches), select “SMALL.”

•If you have selected “NO” for the subwoofer, you can only select “LARGE” for the front speakers.

•If you have selected “SMALL” for the front speakers, you cannot select “LARGE” for the center, surround, and surround back speakers.

•If you have selected “SMALL” for the surround speakers, you cannot select “LARGE” for the surround back speakers.

•If you have selected “NONE” for the surround speakers, the surround back speakers are fixed to “NONE.”

7For measuring unit:

Select one of the following.

meter	: Select this to set the distance by meter.
feet	: Select this to set the distance by feet.

7For each speaker:

Set the distance from the listening point within the range of 0.30 m (1.0 ft) to 9.00 m (30.0 ft), in 0.15 m (0.5 ft) intervals.

Notes:

•You cannot set the speaker distance for the speaker you have selected “NO” or “NONE” for on the SPEAKER SETTING submenu.

•This setting is not valid for the DVD MULTI playback mode.

	C	3.6 m
L	R
		(12 ft)
30˚	30˚	3.3 m
		(11 ft)
		3.0 m
		(10 ft)
90˚	90˚	2.7 m
		(9 ft)
	2.4 m
	(8 ft)
	2.1 m
LS	(7 ft)	RS
60˚	60˚

LSB RSB

EX. In the above case, set the speaker distance as follows:

Subwoofer (SUBWFR)	SUBWOOFER:	3.60 m (12.0 ft)
Left front (L)	FRONT L SP:	3.00 m (10.0 ft)
Right front (R)	FRONT R SP:	3.00 m (10.0 ft)
Center (C)	CENTER SP:	3.00 m (10.0 ft)
Left surround (LS)	SURR L SP:	2.40 m (8.0 ft)
Right surround (RS)	SURR R SP:	2.40 m (8.0 ft)
Left surround back (LSB)	SBACK L SP:	2.70 m (9.0 ft)
Right surround back (RSB)	SBACK R SP:	2.70 m (9.0 ft)

36