ProForm PFSY59001 user manual Cable Assembly

18.Attach a Bumper (40) to the Press Front Leg (20) with a 1” Tap Screw (80).

Press a 3” Round Inner Cap (78) into the top of the Press Leg Lever (90).

Lubricate a 1/2” x 4” Bolt (68). Attach the Press Leg Lever (90) to the Press Base (6) with the Bolt and a 1/2” Nylon Jamnut (36).Note: Do not over tighten the Nylon Jamnut; the Press Leg Lever must be able to pivot easily.

19.Insert two 2” Square Inner Caps (28) into the Leg Lever (41).

Attach a Bumper (40) to the Butterfly Front Leg (3) with a 1” Tap Screw (80).

Lubricate a 3/8” x 3” Bolt (88). Attach the Leg Lever (41) to the Butterfly Front Leg (3) with the Bolt and a 3/8” Nylon Jamnut (63).Note: Do not over tight- en the Nylon Jamnut; the Leg Lever must pivot easily.

CABLE ASSEMBLY

20.IMPORTANT: While assembling the cables, do not over tighten the bolts and nuts attaching the pulleys. The pulleys must be able to turn freely. Refer to the Cable ID Chart on page 26 for help identifying the cables.

Locate and open the parts bags labeled “CABLE ASSEMBLY” and “PULLEYS.”

Locate the Butterfly Cable (73), which is the shorter cable of the two that have eyelets on both ends. Attach the Butterfly Cable to the Right Pivot Arm (85) with a 5/16” x 2 1/4” Shoulder Bolt

(79) and a 5/16” Nylon Jamnut (105).

21.Wrap the Butterfly Cable (73) over a “V”-Pulley (27). Attach the Pulley and a Large Cable Trap (32) to the bracket on the Butterfly Upright (1) with a 3/8” x

2 1/2” Bolt (87) and a 3/8” Nylon Locknut (50).

11

18
	78
	90
	40
		20
68	80
Lubricate	36	6
19	Lubricate		88
			28
	63		41
	40
		80	28
	3
20
	79
73	105	85
21
		50
87	32
	27
	73	1