ProForm PFSY59001 user manual TROUBLE-SHOOTING and Maintenance, Tightening the Cables

Page 24

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened.

To tighten the cables, first insert the weight pin into the middle of the weight stack. Slack can be removed from these cables several ways:

See drawing 1. Loosen the 1/2” Plain Nut (100) on the

1

Weight Cable (72) bolt, away from the 1/2” Washer (11).

72

Screw the bolt a few turns into the Weight Tube (17).

Retighten the 1/2” Plain Nut down onto the 1/2” Washer.

100

 

 

11

17

See drawing 2. Remove either the upper or lower 3/8”

 

 

Nylon Locknut (50) and 3/8” x 2” Bolt (54) from the

2

 

Adjustable Pulley Plates (23). Remove the 3 1/2” Pulley

 

 

 

(24) and the Cable Trap (25). Reattach the 3 1/2” Pulley

 

 

and the Cable Trap to a hole closer to the center of the

54

23

Adjustable Pulley Plates with the 3/8” x 2” Bolt and 3/8”

 

 

 

Nylon Locknut.

25

 

 

50

Either set of Adjustable Pulley Plates (23) can be adjust-

 

 

24

ed in this manner.

 

Do not over tighten the cables. If the cables are over tightened, the top weight will be lifted off the weight stack.

If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and re-install it.

If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

24

Image 24
Contents QUESTIONS? Model No. PFSY59001 Serial NoCustomer HOT Line Table of Contents Important Precautions Before YOU Begin DecalAssembly Make Assembly EasierFrame Assembly Do not tighten the Nylon Locknuts 50 yet Do not tighten the Nylon Locknuts yet Locate and open the parts bag labeled ARM Assembly Tighten the Nylon Locknuts 50 used in stepsPage Cable Assembly Page Page Weight Cable is in the groove of the Pulley Page Page Page Cable Trap is oriented to hold the Cable in place Seat Assembly Locate and open the parts bag labeled Seat AssemblyPage Adjustments Changing the Weight SettingAttaching the LAT BAR or AB Strap to High Pulley Station Adjusting the Backrest Adjusting the Curl PADAttaching the AB Strap to the AB Pulley Station Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams Leg Press Cable Press Upright Ab CableButterfly Cable Left ArmWeight Cable Cable ID Stack Low Pulley Part Identification CHART-Model No. PFSY59001 R0402AX 4 Bolt X 5 1/2 Bolt X 6 Bolt 2 x 2 1/2 Inner Cap 2 Square Inner Cap Round Inner Cap Part LIST-Model No. PFSY59001 Key No. Qty DescriptionExploded Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT