ProForm PFSY59001 user manual

Page 16

38.Wrap the Weight Cable (72) around a 3 1/2” Pulley (24). Attach the Pulley and a Cable Trap (25) between the lowest holes in the Adjustable Pulley Plates (23) hanging from the Ab Cable (47) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50).

Be sure that the Cable Trap is turned to hold the Cable in place.

39.Remove the preassembled 3/8” x 1 3/4” Bolts (57) from the Small Pulley Plates (22).

Wrap the Weight Cable (72) around a 3 1/2” Pulley (24). Attach the Pulley between two Small Pulley Plates (22) with a 3/8” x 1 3/4” Bolt (57) and a 3/8” Nylon Locknut (50).

40.Wrap the Weight Cable (72) around a 4 1/2” Pulley

(82)in the direction shown. Attach the Pulley to the bracket on the Press Top Frame (9) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50).

41.Place a 1/2” Washer (11) on top of the Weight Tube (17).

Thread a 1/2” Plain Nut (100) halfway onto the bolt on the Weight Cable (72). Screw the bolt on the Weight Cable into the Weight Tube (17) a couple of turns.

Tighten the 1/2” Plain Nut (100) down onto the 1/2” Washer (11).

38

47

 

54

23

 

25

50

 

24

 

 

72

39

 

24

72

 

50

57

 

22

40

 

54

72

 

82

50

 

9

Bracket

 

41

 

72

 

100

 

11

 

17

 

16

Image 16
Contents Model No. PFSY59001 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Before YOU Begin DecalAssembly Make Assembly EasierFrame Assembly Do not tighten the Nylon Locknuts 50 yet Do not tighten the Nylon Locknuts yet Locate and open the parts bag labeled ARM Assembly Tighten the Nylon Locknuts 50 used in stepsPage Cable Assembly Page Page Weight Cable is in the groove of the Pulley Page Page Page Cable Trap is oriented to hold the Cable in place Seat Assembly Locate and open the parts bag labeled Seat AssemblyPage Changing the Weight Setting AdjustmentsAttaching the LAT BAR or AB Strap to High Pulley Station Adjusting the Curl PAD Adjusting the BackrestAttaching the AB Strap to the AB Pulley Station Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams Leg Press Cable Press Upright Ab CableButterfly Cable Left ArmWeight Cable Cable ID Stack Low Pulley Part Identification CHART-Model No. PFSY59001 R0402AX 4 Bolt X 5 1/2 Bolt X 6 Bolt 2 x 2 1/2 Inner Cap 2 Square Inner Cap Round Inner Cap Part LIST-Model No. PFSY59001 Key No. Qty DescriptionExploded Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT