ProForm PCTL99011 Problem The walking belt slows when walked on, Belt has shifted to the left

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be-

come damaged. Remove the key andUNPLUG THE

POWER CORD . Using the allen wrench, turn both rear roller adjustment bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each side of the walking belt 7 to 10 cm (3 to 4 in.) off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat

until the walking belt is properly tightened.

b

7–10 cm

Rear Roller Adjustment Bolts

c. If the walking belt still slows when walked on, please call our toll-free HELPLINE.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:	a. If the walking belt is off-center, first remove the key
	and UNPLUG THE POWER CORD		. If the walking
	belt has shifted to the left,		use the allen wrench to
	turn the left rear roller bolt clockwise 1/2 of a turn;			if
	the walking belt has shifted to the right,			turn the
	bolt counterclockwise 1/2 of a turn. Be careful not to
	overtighten the walking belt. Plug in the power cord,
	insert the key and run the treadmill for a few minutes.
	Repeat until the walking belt is centered.
	b. If the walking belt slips when walked on, first remove
	the key and	UNPLUG THE POWER CORD		. Using
	the allen wrench, turn both rear roller bolts clockwise,
	1/4 of a turn. When the walking belt is correctly tight-
	ened, you should be able to lift each side of the walk-
	ing belt 7 to 10 cm (3 to 4 in.) off the walking platform.
	Be careful to keep the walking belt centered. Plug in
	the power cord, insert the key and carefully walk on
	the treadmill for a few minutes. Repeat until the walk-
	ing belt is properly tightened.

a

b

PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com

CDs and videos are played

SOLUTION:	a. With the key inserted in the console, press one of the Incline buttons.		While the incline is
	changing, remove the key.	After a few seconds, re-insert the key. The treadmill will automati-
	cally rise to the maximum incline level and then return to the minimum level. This will recalibrate
	the incline.

24