12.IMPORTANT: To avoid damaging the Crossbar (107), do not use power tools and do not overtighten the #10 x 3/4" Screws (2). Orient the Crossbar (107) as shown. Attach the Crossbar to the Handrails (82, 83) with four #10 x 3/4" Screws (2) and four #10 Star Washers (12); do not tighten the Screws yet.
Insert the Console Frame (102) into the Handrails (82, 83). Attach the Console Frame with four 1/4" x 1" Patch Bolts (9); do not tighten the Patch Bolts yet. Be careful not to pinch the Upright Wire (87).
Tighten one #10 x 3/4" Screw (2) in each end of the Crossbar (107); do not overtighten the Screws. Then, tighten the other #10 x 3/4"
Screw (2) in each end of the Crossbar. Tighten the four 1/4" x 1" Patch Bolts (9).
13.Firmly tighten two 5/16" x 1" Patch Bolts (4) and the four 5/16" x 1" Flat Head Patch Bolts (14) (only one side is shown).
With the help of a second person, hold the con- sole assembly near the Right Handrail (83) and the Left Handrail (not shown).
Connect the Upright Wire (87) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire.
Connect the ground wire from the console as- sembly to the Console Ground Wire (52).
12 |
|
|
|
|
|
First |
| 9 |
|
| 102 |
212 |
|
| |||
107 |
|
| |||
82 |
|
| First |
| |
|
|
| 9 | ||
|
|
|
| 212 | |
|
|
|
| 83 | 87 |
|
|
|
|
| |
13 | Console |
| Console | ||
|
| ||||
| Assembly |
|
| Wire | |
Console |
|
|
| 87 | |
Wire |
|
|
|
|
|
87 |
|
|
Wire |
| Ground Wire 52 |
Tie |
| |
4 | 14 | 83 |
| ||
|
|
12