ProForm 705 ZLT manual Problem Solution

Page 27

PROBLEM:

SOLUTION:

The walking belt is off-center or slips when walked on a. If the walking belt is off-center, first remove the

key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left idler roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

b. If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts clock- wise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walk- ing platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

a

b

27

Image 27

Contents Model No. PETL79810.0 Serial No QUESTIONS?Table of Contents Important Precautions Instructions Save TheseBefore YOU Begin Assembly Make sure that the power cord is unplugged Repeat this step on the other side TreadmillDo not fully fold the Frame yet See the inset drawing. Tie the wire tie Be careful not to pinch the Upright WireFully tighten the Patch Bolts yet Page Patch Bolts yet Page Page Screws, and then tighten each of them Page Troubleshooting HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor Care and MaintenanceAustralia Operation and AdjustmentHOW to Plug in the Power Cord PRE-LUBRICATED Walking BeltDiagram Features of the ConsoleConsole Start the walking belt HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleFor several seconds, each time the incline changes Measure your heart rate if desired HOW to USE a Preset Workout Select a preset workoutMonitor your progress with the matrix and the displays Insert an iFit card and select a workout HOW to USE AN Ifit WorkoutHOW to USE the Stereo Sound System Information ModeHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillProblem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked onProblem Solution Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key No. Qty Description Part LIST-Model No. PETL79810.0Qty Exploded Drawing A-Model No. PETL79810.0 R0710A Exploded Drawing B-Model No. PETL79810.0 R0710A Exploded Drawing C-Model No. PETL79810.0 Exploded Drawing D-Model No. PETL79810.0 R0710A Recycling Information Ordering Replacement Parts