ProForm 705 ZLT See the inset drawing. Tie the wire tie, Be careful not to pinch the Upright Wire

3. See the inset drawing. Cut the plastic tie near	3
the Upright Wire (87).			Plastic Tie
Attach a Wheel (96) to the Base (95) with the
3/8" x 2" Bolt (8) and the 3/8" Nut (10) that you					89
removed in step 1. Do not overtighten the Nut;
the Wheel must turn freely.			8
Press a Base Cap (89) into the Base (95).
			96	95	Cut
			10
					87
4. Identify the Right Upright (85), which is marked	4
with a “Right” sticker. Hold the Right Upright				85
near the Base (95) as shown.
See the inset drawing. Tie the wire tie in the		87
Right Upright (85) securely around the end of			Wire Tie		87
the Upright Wire (87). Then, pull the other end
of the wire tie until the Upright Wire is routed					95
completely through the Right Upright.			85
			Wire
	87		Tie
5. Hold the Right Upright (85) against the Base	5				7
(95). Be careful not to pinch the Upright Wire
(87). Insert two 3/8" x 4" Patch Bolts (7) and a			85	3
3/8" x 1 1/2" Patch Bolt (3) with three 3/8" Star
Washers (11) into the Right Upright.				11	11
Tighten the 3/8" x 4" Patch Bolts (7) and the
3/8" x 1 1/2" Patch Bolt (3) until the heads of the					87
Patch Bolts touch the Right Upright (85); do not
fully tighten the Patch Bolts yet.					95
	8