ProForm 705 ZLT manual

Page 14

16.If necessary, press the Left Tray (103) and the Right Tray (104) into the console assembly.

17.Raise the Frame (55) to the position shown.

Have a second person hold the Frame until this step is completed.

Orient the Storage Latch (51) so that the large barrel and the latch knob are oriented as shown. Attach the Latch Bracket (6) and Storage Latch (51) to the Base (95) with two 3/8" x 2" Bolts (8) and two 3/8" Nuts (10).

Attach the upper end of the Storage Latch (51) to the bracket on the Frame (55) with a 3/8" x 2" Bolt (8) and a 3/8" Nut (10). Note: It may be necessary to move the Frame back and forth to align the Storage Latch with the bracket.

Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 24).

16	103	Console
		Console
		Assembly
		104

17	55
	55
10	8
Latch Knob	51
Latch Knob	Large
	Barrel
	6	95
	10	8
		8

18.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 26 and 27).

14

Image 14

Contents QUESTIONS? Model No. PETL79810.0 Serial NoTable of Contents Important Precautions Save These InstructionsBefore YOU Begin Assembly Do not fully fold the Frame yet Make sure that the power cord is unpluggedRepeat this step on the other side Treadmill Fully tighten the Patch Bolts yet See the inset drawing. Tie the wire tieBe careful not to pinch the Upright Wire Page Patch Bolts yet Page Page Screws, and then tighten each of them Page Care and Maintenance HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor TroubleshootingPRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord AustraliaConsole DiagramFeatures of the Console Insert the key into the console HOW to Turn on the PowerHOW to USE the Manual Mode Start the walking beltFor several seconds, each time the incline changes Measure your heart rate if desired Monitor your progress with the matrix and the displays HOW to USE a Preset WorkoutSelect a preset workout HOW to USE AN Ifit Workout Insert an iFit card and select a workoutInformation Mode HOW to USE the Stereo Sound SystemHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useProblem The walking belt slows when walked on TopProblem Solution Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencySuggested Stretches Part LIST-Model No. PETL79810.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. PETL79810.0 R0710A Exploded Drawing B-Model No. PETL79810.0 R0710A Exploded Drawing C-Model No. PETL79810.0 Exploded Drawing D-Model No. PETL79810.0 R0710A Ordering Replacement Parts Recycling Information