ResMed S9 VPAP Tx manual Filling the water tub

Page 12

5.Connect the S9 VPAP Tx to the Tx Link via USB serial cable.

6.Plug the other end of the power cord into the power outlet.

7.Connect one end of the air tubing firmly onto the air outlet.

8.Connect the assembled mask system to the free end of air tubing.

The S9 VPAP Tx does not use the SD Card function to store data. All necessary data is transferred via Tx Link and available through the EasyCare Tx software.

Notes:

•• Always ensure that the S9 VPAP Tx is placed in an area where the alarm LED indicators are clearly visible.

•• Place the power supply unit away from the H5i to allow for adequate ventilation.

Filling the water tub

WARNING

Beware of electrocution. Do not immerse the device, humidifier, power supply or power cord in water. In the event of a spill, disconnect the device from the power supply and let the parts dry. Always unplug the device before cleaning and make sure that all parts are dry before plugging in the device.

CAUTION

•• Do not overfill the water tub as water may enter the device and air tubing.

•• Do not use any additives (eg, scented oils and perfumes).These may reduce the humidification output of the H5i and/or cause deterioration of the water tub materials.

•• Take care when handling the H5i as the water/water tub may be hot. Allow 10 minutes for the heater plate and any excess water to cool.

•• If liquids are inadvertently spilled into or on the H5i, unplug the device from the power outlet. Disconnect the H5i from the device and allow it to drain and dry before re-using.

8

Page 11 Page 13
Image 12
Page 11 Page 13
Contents S9 Vpap Tx Page S9 Vpap Tx Contents General warnings and cautions Welcome S9 Vpap Tx indications for useS9 Vpap Tx contraindications S9 Vpap Tx adverse effectsS9 Vpap Tx at a glance Masks Supplemental oxygenAntibacterial filters HumidifierTherapy mode Description Therapy modesS9 Vpap Tx basics Key FunctionSetting up the S9 Vpap Tx Filling the water tub English Mask and air tubing settings Mask type SettingsAir tubing Specifications Settings Navigating the menus About the menusHome menu Changing settings via the Home menu Humidity levelClimate Control Mask FitViewing the treatment screens Treatment screen parameters Parameter Modes DescriptionSetup menu Setup menu accessSettings ConfigurationClinical setup menu parameters Parameter ModesRange Description Ü ü ü ü ü ü ü üParameter Modes Range Description Ü ü üLED Service Info menuParameter Description Temperature Managing Climate ControlMode Heated tubeDelivering therapy Adding supplemental oxygen To add supplemental oxygenCleaning and maintenance Filter EfficiencyWorking with alarms Alarms menuTesting the alarms Troubleshooting Problem/Possible cause SolutionNo display Insufficient air delivered from the deviceAlarm is activated and the LCD screen display disappears Water splashing on your face from the H5iLeaking water tub Air feels too warm/cold in the maskTechnical specifications General technical specificationsS9 Vpap Tx technical specifications Pneumatic flow path Value Range Display resolution Flow maximum at set pressuresDisplayed values MinSymbols ServicingLimited warranty ProductPage GLO Multi
Top Page Image Contents