HOW to USE a Target Toning Workout

1.Turn on the console.

See step 1 on page 15.

2.Select a target toning workout.

To select a target toning workout, press the Workout button repeatedly until the words TAR- GET TONING 1 or TARGET TONING 2 appear in the upper display.

TRpSE T T f"_llT I__VS'_ l

I"!,m"3l"l	.... ==---	¢3
U'LJ U	.... ==---	U
TiME	mmmmmlmB	RPM
	Profile

When you select a target toning workout, the name of the workout and the workout time will

appear in the displays and a profile of the resis- tance levels of the workout will scroll across the

center display.

3.Begin pedaling to start the workout.

Each workout is divided into 30 one-minute seg- ments. One resistance level and one target rpm (revolutions per minute) setting are programmed for each segment. Note: The same resistance level and/or target rpm setting may be programmed for consecutive segments.

During the workout, the workout profile will show your progress (see the drawing above). The flash- ing segment of the profile represents the current segment of the workout. The height of the flashing segment indicates the resistance level for the cur- rent segment. At the end of each segment of the workout, a series of tones will sound and the next segment of the profile will begin to flash. If a differ- ent resistance level is programmed for the next segment, the resistance level will appear in the display for a few seconds to alert you. The resis- tance of the pedals will then change.

As you exercise, the console will display a variety of exercise instructions that will help you get the most benefit from your workout. For example, the console may instruct you to PEDAL BACKWARD, USE UPPER BODY, or FOCUS LOWER BODY during certain segments of the workout.

As you exercise, you will be prompted to keep your pedaling pace near the target rpm setting for the current segment. When the words PEDAL FASTER appear in the upper display or the GO FASTER indicator on the pace guide is lit, increase your pace. When the words PEDAL SLOWER appear or the GO SLOWER indicator is lit, decrease your pace. When the words PEDAL- ING IN RANGE appear or when the center indica- tor is lit, maintain your current pace.

G0 FASTER

G0 SLOWER

IMPORTANT: The target rpm settings are intended only to provide motivation. Your actu- al pace may be slower than the target rpm set- tings. Make sure to pedal at a pace that is com- fortable for you.

If the resistance level for the current segment is too high or too low, you can manually override the setting by pressing the Resistance decrease and increase buttons. However, when the current seg- ment ends, the pedals will automatically adjust to the resistance level for the next segment.

If you stop pedaling for several seconds, a series of tones will sound and the workout will pause. To restart the workout, simply resume pedaling. The workout will continue until the last segment of the profile flashes and the last segment of the workout ends.

When the last segment of the workout ends, the words PROGRAM DONE will appear in the upper display.

4.Follow your progress with the displays.

See step 4 on page 15.

5.Measure your heart rate if desired.

See step 5 on page 16.

6.Turn on the fan if desired.

See step 6 on page 16.

. When you are finished exercising, the console will turn off automatically.

See step 7 on page 16.