ProForm 831.23844.0 user manual Upright, secure the Wire Harness with a rubber band

Page 35

Tip: Do not pinch the Wire Harness (100).

Start all screws before tightening any of

them.	Wire Tie

Have another person hold the Upright (2) near the Frame (1). Locate the wire tie in the Upright. Tie the lower end of the wire tie to the Wire Harness (100). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness from falling inside

the Upright, secure the Wire Harness with a rubber band.

Attach the Upright		(2) to the Frame		(1) with four
M10	x 20mm Patch	Screws	(79), and four M10		79 78
Split	Washers (78). Do not		tighten	the Patch	78

Screws yet.

, Orient the Water Bottle Holder	(5) as shown	4
and slide it onto the Upright (2). Attach the		4
and slide it onto the Upright (2). Attach the
Water Bottle Holder with two M4 x 32mm
Screws (95).		Do not pinch	the
		Wire Harness	(100)

Tip: Do not pinch the Wire Harness (100).

Slide the Console Cover (96) onto the Upright

(2)and move it downward to the Water Bottle Holder. Then, insert the Console Bracket (3) into the top of the Upright. Attach the Console Bracket with four M4 x 16mm Screws (84).

Do not pinch the Wire Harness (100)

7

Image 35

Contents Sears, Roebuck and Co., Hoffman Estates, IL Assembly Operation Maintenance Part List and DrawingModel No Serial No Table of Contents Important Precautions Before YOU Begin Assembly Cover Attach the other Wheel not shown in the same wayRepeat this step for the Left Frame Do not pinch the Wire Harness Upright, secure the Wire Harness with a rubber bandDo not pinch Wires during This step Attach the Right Upper Body Leg 31 Same way Repeat this step for the other Pedal Arm Axle not shown Arm AxleOnal HOW to USE the Elliptical Exerciser HOW to Change the Incline of the Ramp Features of the Console Center display HOW to USE the Manual ModeSelect the manual mode Follow your progress with the displaysHOW to USE a Cross Training Workout Will turn off automatically Perform the first strength exercise when promptedWhen you are finished exercising, the console Continue the cross training workoutSelect a target toning workout HOW to USE a Target Toning WorkoutSelect a calorie goal workout HOW to USE a Calorie Goal WorkoutSelect the high performance workout SH PERFuR, ,R,,LEIfScrews in the shields--note which size of screw Maintenance and TroubleshootingHOW to Adjust the Belt Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Qty Description Part LIST--ModelWire Harness Exploded Drawing A--Model No .23844.0 RO708B 295 MY-HOM E DAY Full WarrantyElliptical Exerciser Table of Contents Important Precautions Before YOU Begin Assembly Attach the other Wheel not shown in the same way Upright, secure the Wire Harness with a rubber band Do not pinch Wires during This step Attach the Right Upper Body Leg 31 Same way Arm Axle Onal HOW to USE the Elliptical Exerciser HOW to Change the Incline of the Ramp Features of the Console LFtuS 9B,O ERRB5 Upper BDg SHDULuEP PPES5 ULJ U Ur uur,=,c SH PERFuR, ,R,,LEIf Maintenance and Troubleshooting Exercise Guidelines Suggested Stretches Part LIST--Model Wire Harness Exploded Drawing A--Model No .23844.0 RO708B 295 DAY Full Warranty